5号充电电池订做/5号充电电池批
产品规格书 PRODUCT SPECIFICATION
"The discharge capacity of contrast, under the conditions of different temperature in 25 ℃ under the condition of normal temperature after full charge of the battery, as shown in the table below normal temperature and high temperature to the capacity of 0.2 C to 6.0 V, low temperature is 0.2C to5.0 V discharge capacity.the time between charging and discharging must beyond 3 hours.
不同温度件下的放电容量对比，即在25℃常温件下电池满充电后，在下表示常温和高温度下以0.2C放至6.0V的容量，低温为0.2C放电至5.0V的容量。如果充电和放电温度不是同温度时，温度变化的间隔时间要求是3小时。"
The pressure on the surface of the fully charged cell do not stop being raised until 17.2 Mpa when the cell is crushed by two flat surfaces.(Max13kN) ."No explosion, No fire.”
挤压：满充电电池，被两平板挤压。挤压的{zd0}压强为17.2Mpa,{zd0}作用力为13kN。当达到{zd0}值即停止。电池不爆炸，不起火"
The temperature of the baking box which contains cell is raised to 100±2℃ at a rate of 5℃/min and then holded for ten minutes. "No explosion, No fire .
高温：满充电电池在烘箱中测试。烘箱自室温起以5℃/min的升温速率升至100±2℃，并在100±2℃温度下保持10min。电池不爆炸，不起火"
After full charge, the positive and negative polarities are connected together by a copper wire whose resistance is less than or equal to 0.1Ω.
短路：满充电电池用电阻不大于0.1Ω的铜导线连接其正负极至电池体温度接近室温。
The cell is overcharged to 9.0V with a current of 1C and holded for 8 hours.
过充：电池在1C恒流恒压下过充至9.0V，并保持8小时。
Standard environmental test condition/测试件：
Unless otherwise specified, all tests stated in this Product Specification are conducted at below condition.
Temperature：25±2℃
Relative humidity ：65±20%
除特别说明外，本规格书中有测试均在以下环境中进行。
温度：25±2℃ 相对湿度：65±20%
.虎泉实业///5号充电电池订做/5号充电电池批发
