您好,欢迎来到中国企业库   [请登陆]  [免费注册]
小程序  
APP  
微信公众号  
手机版  
 [ 免责声明 ]     [ 举报 ]
企业库免费B2B网站
搜产品 搜企业
客服电话:400-000-8722
企业库首页>资讯
行业

I would like to ask; turbocharged mill is even. « China trip 中国行

作者:企业资讯策划团队 来源:rwfb 发布时间:2010-04-14 浏览:223

Question:
I would like to ask; turbocharged mill is even.

Answer:
turbocharger is actually an air compressor. In order to improve the engine output power. Engine cylinder capacity does not change the premise that only by increasing under the condition of the air enter the cylinder compression ratio to achieve the increased output made
the purpose of motivation ~ its working principle is the use of engine exhaust emissions from engine exhaust port as a driving force to turbine impeller side room. At the same time, supercharger impeller and another side room is directly connected to the pressurized round. Attached with a gas pressurized chamber to consider. In addition to a concern from the gas pressure the West into the air into the engine cylinder. Increase has reached the purpose of the air inside the engine.

first clear that the system is the use of turbo-charged engine exhaust work. If you do not, white smoke is discharged to waste. (From this point I do not see how to stop or restrict the use of turbocharged economy) is further from the control point of view, the addition of a turbocharger controller to start or be detrimental to the turbocharger the structure (since it is pressurized, of course, is the better interface. to reduce the rate of leakage Mody ~)

turbocharged As for shortcomings, it should be turbocharged throttle response on the speed of the ~ should be The working principle of the reasons. Blasted down the throttle, the first jet fuel to the engine, and then accelerate the car forward. Fertilizer its discharge to promote the turbine. ~ ~ Therefore, in order to pressurized turbocharged slow to respond to some. The same problem also appears in the case of closed throttle (without regard to his foot on the brake).

Answer:
In short, it is the use of engine exhaust gas driven turbocharger allows the engine intake pressure of a device. In general can increase engine power.2006-04-30
问题:
请问;涡轮增压是甚磨.

回答:
涡轮增压其实就是一个空气压缩机。为了提高发动机的输出功率。再不改变发动机气缸容量的前提条件下只有用增加输入气缸的空气的压缩比来达到增加发
动机输出功率的目的~其工作原理就是利用发动机尾气排放口排出的发动机废气为动力,来推动涡轮室里边的叶轮。同时叶轮又和增压室里边的增压轮直接相连。增压室一头连着气虑。另外一头把从气虑西进来的空气压进发动机的汽缸。已达到增加发动机里边空气的目的。

  首先要明确一点的是,涡轮增压系统是使用发动机的废气进行工作的。如果你不用,废气白白的排出去也是浪费。(从这一点上我看不出停止或限制使用涡轮增压的经济性)再有就是如果从控制的角度考虑,增加一个涡轮增压启动与否的控制器也不利于涡轮增压的结构(既然是增压,当然是接口越少越好。降低漏气的比率么~)

  至于涡轮增压的缺点,就应该是涡轮增压对油门的响应速度了~应为工作原理的原因。狠命的踩下油门,首先燃油要喷射到发动机里,然后汽车向前加速。肥其排出,推动涡轮。才能增压~~所以涡轮增压要反应迟钝一些。同样的问题也出现在收油门的情况(不考虑踩煞车)。

回答:
简单说,就是利用发动机尾气带动涡轮增压器使发动机进气压力增大的一种装置。一般可提高发动机的功率。2006-04-30

标签: , , ,

郑重声明:资讯 【I would like to ask; turbocharged mill is even. « China trip 中国行】由 企业资讯策划团队 发布,版权归原作者及其所在单位,其原创性以及文中陈述文字和内容未经(企业库www.qiyeku.com)证实,请读者仅作参考,并请自行核实相关内容。若本文有侵犯到您的版权, 请你提供相关证明及申请并与我们联系(qiyeku # qq.com)或【在线投诉】,我们审核后将会尽快处理。
会员咨询QQ群:902340051 入群验证:企业库会员咨询.
免费注册只需30秒,立刻尊享
免费开通旗舰型网络商铺
免费发布无限量供求信息
每天查看30万求购信息