纺织、服装英文验货手册
一、纺织品各部位缺陷描述
Accessories Defect Terms :
1. Missing sequins ['siːkwɪns]珠片 at ______ 于____处少了珠片=missing beading
2. In-secured sequins at ____________ 于____处的珠片不稳固
3. Damaged/broken button at __________ 于__________ 烂扣
4. Sharp point at _________________ 于____处有尖角
5.broken Beading & embroidery 钉珠&绣花坏
6.Beads stitching are not secure 珠子未钉牢
7.Embroidery stitching too tight 绣花线太紧
8.Embroidery stitching too loose 绣花线太松
9. Missing button / label / badge [bædʒ] 漏钮 / 漏唛头 / 漏章
10.Button position not well match buttonhole. 钮与钮门位置欠配合
11.Button inside out 钮的底面倒置
12.Button marking not removed. 点钮笔痕没有清除
13.Damaged button/buttonhole 钮烂/烂钮门
14.Rusted stud/rivet 工字钮生锈
15.Paint peel off on stud 工字钮颜色脱落
16.Button and buttonhole not aligned cause bulge[bʌldʒ]. 钮及钮门位置不配,引致谷起
17. Buttonhole too small to allow button to pass through. 钮门太细, 钮不能顺利通过;
18. Uncut buttonhole / partially部分的 cut buttonhole 钮门未幵 / 钮门未开尽:
19.Ragged edges at buttonhole 钮门纱线不清
20. Broken buttonhole stitches 钮门断线
21. Button thread easily pulled out. 钉钮线容易拉脱
22. Snap / rivet easily pulled off.吸钮、撞钮容易拉脱
23. Buttonhole is not match button size 钮洞尺寸与钮扣大小不相配
24. Button misplaced 钮扣位置不对
25.Buttonhole misplaced 钮洞位置不对
26.Button is not sewing security 钮扣未钉牢 button sewn insecure
27. Button is sewn too tight 钮扣钉得太紧
28.Buttonhole is fray 钮洞有毛口-
29.Key buttonhole density is too loose 凤眼钮洞的车缝线步太疏
30. Key buttonhole is misplaced 凤眼钮洞位置不对
31.Snap misplaced 揿钮位置不对
32.Snap tape is misplaced 揿钮扁带位置不对
33.Snap tape setting not well 揿钮扁带装得不好
34. There is bubble on buttonhole area 钮洞周围有气泡
35. Hood and bar is misplaced 裙扣位置不对,
36. Hole at zip top / end 拉链顶 / 尾有洞
37. Zipper setting is twisting 拉链装得扭曲
38.Shoulder pad attach to garment not security 肩棉未钉牢
39. Shoulder pad not cover well 肩棉未包好;
40.Velcro is misplaced 魔术贴位置不对
41. Waistband belt setting is not straight 腰耳装得不直
42. Waistband belt length and width are uneven 腰耳的长、宽不一致
43. ★Incomplete adhesive on interlining. 黏朴未完全黏好
44. Strike through of adhesive on interlining. 黏朴胶露面
45.Strike back of adhesive on interlining. 黏朴脱落
46. Blistering起泡 occurred on interlining. 黏朴起泡
47. Insecure shoulder pad attached. 肩棉钉缝不稳
48.Label placement incorrect. 唛头位置不正确 =label misplaced
49.Care label content not as specified. 成份唛内容不符合要求
50. Main label and size/content label are set too closed 主唛与尺码成份唛装得太靠近
51. Main label （setting is） misplace 钉主唛不正确
52. Wrong care label sewn on garment. 成份唛车错位置
53. Label not properly secured. 唛头车缝不稳
54. Label sewn beyond label edge. 唛头车缝太入
55.Label sewing seam uneven / puckered. 唛头车缝不平均或起皱
56.Wrong accessories used. 用错辅料
57.Button out of line =misaligned钮位不成直线
58. Improper button position 纽扣位置不适当
59. In-secured plastic cord end setting on the elastic 橡皮筋的胶绳制脱落
60. Shanking beading around embroidery edge 绣花边的订珠震动不顺直
61. Wrong simulated仿造的 jewelry (pink instead of white）仿珠宝颜色是粉红色不是白色
Color Defect Terms :
1.Color shade difference within same garment (gray scale 4)
同一件衣服内有色差-灰尺级别4
2.Color changed difference within front/back panel (gray scale 4)
于前后幅间有颜色变异-灰尺级别4
3. Wrong color pattern at ___________ 于____处错了颜色图案
4. Paint peel off on ____________ 于____处颜色脱落
5.Color shading 色差
6. Color shading within one garment. 同一件衣服内有色差。
7.Color shading between trims and body. 配件与衫身之间有色差。
8. Shade differs from approved standard. 颜色与批核色版不同。
9.Shading caused by poor color interlining matching. 纸朴颜色不配合, 引致色差。
Fabric Defect Terms:
1. Missing fabric’s loop at _______ 于____处布身没有毛圈
2. Missing fabric’s pile at ________ 于____处布身没有绒毛
3. Barre起痕 at _________ 于____处布身有花毛、起痕
4. Selvedge布边 along back panel bottom 沿后幅底部有布边
5. Slub 粗纺线yarn 粗纱 at ______ 于____处有粗纱
6. Streaky有条纹的mark 横痕at ________ 于____处有横痕
Packing Defect Terms:
1. Broken export carton 外箱破烂
2. Missing hangtag 漏挂挂牌
3. Smeared 污迹斑斑的printing on bar-code hangtag 电脑条码挂牌印刷不清洁
Workmanship and Appearance Defect Terms:
( Defect on Appearance外观缺陷)
1. Asymmetric collar in size 、shape and length 衣领不对称
2. Deformed 畸形的shell neck shape 领型不正
3. Exceed shell mesh at ______ 于____处之面布网布过多
4. Exposed under placket at top after button fasten 于扣扭处露底贴
5. High-low pocket top 高低袋顶
6. High-low sleeve slit 高低袖叉
7. Missing a part of embroidery 没有了部分绣花
8. Non-center embroidery 绣花不居中
9. Pleat at _______ 于____处打死褶
10. Poor pressing at ________ 于____处熨工差
11. Puckering at ________ 于____处打褶
12. Slant bottom 斜衫脚
13. Slant embroidery pattern at right and left bottom/under armhole
于衣脚及夹底处车花斜了
14. Slant pocket 斜袋
15. Slant shoulder seam to front panel 膊骨斜向前幅
16. Slant sleeve placket/slit/vent 袖叉歪斜
17. Twisted hem at ______ 于____处起豆角边
18. Twisted seam at _____ 于____处扭骨
19. Twisted sleeve/body at side seam 于袖子或衫身侧骨处扭骨
20. Twisted tape/stripe/ strap 扭带
21. Uneven side slit /vent at front and back side 于前后幅间的脚叉不对称
22. Wavy at _______ 于____处起波浪
23.Hiking at front, CF facing too short 吊襟 =ride up
24.Hiking at back, lining too short 吊里
25.Curve at CF zip(too much fullness at CF zip) 前中拉链溶位太多
26.Curve at CF zip because of no easing of zipper. 前中拉链无溶位(引致纽曲)
27.Hiking at back / Hiking at front 后幅吊起 / 前幅吊起:
28.Front panel is bigger than under panel(lining) 前幅底幅细面幅松
29.Lining too big, too short, too small, too long 里布太大, 太短, 太小, 太长
30.Grain lines are not match at front & back panel 前后幅布纹不相称
31.Front length uneven 左右前长不一致;
32.Too loose at shell, Too loose at back/lining, turn insider out 底松, 面松, 向外反
33.Seam binding stitch tension is too tight, causing bottom not smooth. 下摆丝带过紧, 使下摆不平顺
34.Bottom hem is not in line / not straight. 下脚不够不平(直). =uneven/misaligned
35.Twisting hem, puckering at hem 下脚纽纹起豆角.
36.Uneven hem 左右下摆高低不一
37.Vent length uneven 左右开叉长短不一 马甲vest
38.Uneven leg length 长短脚
39.Uneven hem line 衫脚不平均 / 不对称
40.bottom hem is not in line / not straight. 下脚不够不平(直)
41.Twisting hem, puckering at hem 下脚纽纹起豆角..
后续哦。。。。。
