LH8253MH253 Hall-effect sensor is a temperature stable, stress-resistant switch. Superior high-temperature performance is made possible through a dynamic offset cancellation that utilizes chopper-stabilization. This method reduces the offset voltage normally caused by device over molding, temperature dependencies, and thermal stress.
LH8MH includes the following on a single silicon chip: voltage regulator, Hall voltage generator, small-signal amplifier, chopper stabilization, Schmitt trigger, open-drain output. Advanced CMOS wafer fabrication processing is used to take advantage of low-voltage requirements, component matching, very low input-offset errors, and small component geometries.
LHMH8 is rated for operation between the ambient temperatures –40℃ and +85℃ for the E temperature range. The four package styles available provide magnetically optimized solutions for most applications. Package types SO is an SOT-23(1.1 mm nominal height), SQ is an QFN2020-3(0.55 mm nominal height), a miniature low-profile surface-mount package, while package UA is a three-lead ultra mini SIP for through-hole mounting.
The package type is in aHalogen Free version was verified by third party Lab.
Features and Benefits
l CMOS Hall IC Technology
l Solid-State Reliability much better than reed switch
l Omni polar output switches with absolute value of North or South pole from magnet
l Low power consumption(2.6mA)
l High Sensitivity for reed switch replacement
l {bfb} tested at 125℃ for K.
l Small Size
l ESD HBM ±4KV Min
l COST competitive
Applications
l Solid state switch
l Lid close sensor for power supply devices
l Magnet proximity sensor for reed switch replacement in high duty cycle applications.
l Safety Key on sporting equipment
l Revolution counter
l Speed sensor
l Position Sensor
l Rotation Sensor
l Safety Key
091713Page 1Rev. 1.04
